供应


智能制造网供应网 供应超大功率NTC热敏电阻器

供应超大功率NTC热敏电阻器

  • 产地
  • 所在地
  • 暂无
  • 广东

更新时间:2011-11-03

有效日期:已过期

产品详情

NTC热敏电阻器系由特殊配置的金属氧化物陶瓷材料制成,它可用来抑制高的突波电流。相对于受保护电路,热敏电阻器具有较高的电阻。因此会抑制突波电流约1~2秒,在这一段时间内热敏电阻的电阻将因温度升高而下降,直至热敏电阻两端压降到可被忽略的电阻值为止。如图A以电源供应器为例, 在电源开的瞬间,电容器一般阻抗极低,桥式整流器通常承受很大的电流,热敏电阻器特别使用于保护电源供应器。
NTC Thermistor devices are made of a specially formulated metal oxide ceramic material which is capable of suppressing high inrush current surges.
Thermistor devices, being of relatively high resistance, shall limit the inrush current for 1~2 seconds during which time the device decreased in resistance substantially to a point where its voltage drop is negligible .The devices are especially useful in power supplies (see Fig A) because of the extremely low impedance of the capacitor being charged, of which the bridge is ususlly subjected to an exceedingly high current surge at turnon point.
特征
●有效抑止突波电流。
●稳定状态下功率损耗极小(通常仅有1W或小于50W)。
●热及电特性稳定性高。
●宽广的电性规格可供选择。
FEATURES
●High inrush current restriction effect
●Small power loss in stationary state
●(Normally less than 50W power)
●High thermal and electrical stability.
●Wide selection of electrical performances
应用概述
如图B所示,将一NTC热敏电阻与一白热灯丝串联时,可以消除突波电流。若一只NTC热敏电阻无法提供足够之突流限制功能时,二只或更多的热敏电阻可用于串联电路上或供应电路的各个分路上(如图A)。但要注意的是NTC热敏电阻,不可并联于电路上,因为其中一只NTC就可能会传导几乎所有的电流。热敏电阻用于图A所示AC电路的A1或A2处,或是DC电路D1或D2处。
在设计上,当电路刚被打开的瞬间,NTC热敏电阻的阻值高于电路上所有白热灯丝的总电阻值。当电流开始通过时,热敏电阻随时产生「自然」现象,并在1到2秒内,阻值会降到几可忽略。以同样的构想来看电动马达的突波电流,亦可以被抑制到zui低限度。图C表示应用热敏电阻保护直流马达前后突波电流波形的差异。
APPLICATION
As shown in Fig.B, the current surge can be eliminated by placing a NTC thermistor in series with a filament string. Yet, if the resistance of one NTC thermistor does not provide sufficient inrush current limiting functions for your applicantion, 2 or more may be used in series or in separate legs of the supply circuit (Fig.A). Be noticed, the thermistor can not be used in parallel since one unit will tend to conduct nearly all the current available. Thus, thermistor may be used in the AC (point A1or A2)or the DC (point D1or D2) locations in the circuit. (see Fig.A)
The resistance of NTC thermistor is designed higher than the total resistance of NIC thermistor is designed higher than the total resistance of filaments when thermistor shall immediay self-heat. Then, in 1~2 seconds, its resistance will be reduced to a minimum and become insignificant to the total resistance of a circuit. With the same concept, current surges in electric motors can be held to minimum. Fig.C shows a typical DC motor's turn on surge before and after the application of a thermistor to the circuit
选用原则
1.热敏电阻器的zui大工作电流>实际电源回路的工作电流
2.热敏电阻器的标称电阻值
R≥ 式中E为线路电压 l m为浪涌电流
对于转换电源、逆变电源、开关电源、
UPS电源l m=100倍工作电流
对于灯丝、加热器等回路l m=30倍工作电流
1.Maximum operating current >Actual operating current in the power loop
2.Reted zero power resistance at 25℃of which, E: loop voltage, lm: Surge current.
For conversion power, reversion power, switch power,
UPS power, lm=100 times. operating current


免责声明:以上所展示的信息由企业自行提供,内容的真实性、准确性和合法性由发布企业负责,智能制造网对此不承担任何保证责任。

在线询价

 

深圳欧蓝达电子有限公司

型:
其他
联系人:
浮振宁

联系我时,请说明是在智能制造网上看到的,谢谢

商家概况

主营产品:
ptc热敏电阻,NTC热敏电阻,压敏,过热保护传感ptc,彩电消磁用ptc,过流过载保护型,电机马达型ptc
公司性质:
其他

该商家其它产品

16V PPTC自恢复保...

摘要:热敏电阻(PTCR)应用在电子 [详细]

延长灯具寿命的PT...

摘要:热敏电阻(PTCR)应用在电子 [详细]
供应节能灯预热启动型PTC热敏电阻器

供应节能灯预热启...

摘要:热敏电阻(PTCR)应用在电 [详细]

供应LEDPTC热敏电...

摘要:HLMZ2系列PTC热敏电阻是一 [详细]

供应马达启动用PT...

摘要:产品优势:采用带有PTCR的 [详细]

供应MZ4恒温加热...

摘要:PTC加热器就是利用恒温加热 [详细]

供应MZ6过热保护P...

摘要:产品广泛应用在:开关电源 [详细]

供应自恢复保险丝...

摘要:高分子PTC热敏电阻的可设计 [详细]

其它商家同类产品


新手指南
了解智能制造卖家注册买家注册操作指南手机智能在线
旗下子站
智能控制机器人物联网3D打印
站点导航
找资讯找公司找产品找展会品牌商城
本站服务
会员服务企业建站广告服务SEO优化